¶ New Dust Cover Control
Dust cover control has changed for the better. The Premium Linear Magazine now uses servo motors to drive the dust cover through an output on the motion controller. If an output is not available on the controller a limit switch may be used to trigger the dust cover as the spindle moves over the magazine.
All the electronics are tucked nicely into the right end housing on the magazine. A 4 pin screw terminal comes prewired with strain relief. 12-36v is required and can be wired to the motion control board main power or a continuous aux power supply. (If using a seperate power supply that of the motion controller the they must share a ground).
The LED indicates power and goes out whent he IR sensor is triggered.
A toggle switch has been added to manually open and close the dust cover.
The blue dust cover signal wire is connected to an output on the motion controller.
The yellow IR signal wire is connected to an input on the motion controller.
Below is an example showing the connections to the Masso G3/G3 Touch
¶ Masso
